Products

Introduction to the product

What Is It Made Of?

Plastic Lumber primarily consists of all plastic types that are post-consumer waste. Where some products are made using Polyethylene (Multi-layered plastic and consumer plastic waste); some are manufactured with Polystyrene and Polyvinyl Chloride (PVC). A large number of products are also created using a mix of different types of plastics collected from landfills or municipal recycling programs. However, all these kinds of plastics fall under the umbrella category of being environmentally hazardous.

The Environment’s Choice

The recycled products manufactured by Ecoville act as a brilliant replacement to wood and plywood. Apart from being eco-friendly and helping save the environment, these multi-purpose products have a unique set of features and advantages that not only make them superior to contemporary materials but will also make them the preferred choice for generations to come.

Our Range of Products

ALL OUR PRODUCTS ARE AVAILABLE ACROSS THREE BROAD CATEGORIES:

Raw

Polished

Coloured

Ecoville Door Frames/Panels

  • Water resistant
  • Termite resistant
  • Powder free
  • Borer free

Doors made of wood and wooden materials are not only harmful to the environment resulting in depletion of forests; they also create difficulties for the consumers in the long term. Such issues arise because of termite attack, constant repairs, regular maintenance, etc.

Ecoville door frames are built such that the quality does not deteriorate in the long run along with the material being water resistant, termite resistant, powder free and borer free. These features of the product make it an excellent substitute for wood.

Product Storage & Handling

Storage

  • It is recommended for the planks to be stacked horizontally on a flat surface.
  • In case of thinner planks, we advise a base that is 18mm in thickness.
  • Vertical stacks are not advised but if necessary, vertical support must be provided
  • Uniformity in gaps should be maintained between the boards, from one end to another.

Sawing

  • The recommended saws to be used on these products are tungsten carbide tipped saw and fine toothed cross cut saw.
  • Saw blade projection must be properly adjusted above the board for the cut to be clean.
  • Keep the board in motion while sawing to avoid any built-up heat.

Fixing & Fitting

  • If glue has to be applied in the process of fixing, clean and scrape the surface prior to gluing.
  • We recommend using a rubber base glue.
  • If fitting is to be done using screws, our recommendations are pilot hole and full threaded screws.
  • Always ensure that the distance of the screw from the corner is 10 mm on the edge and 25 mm on the face. Hammering the screw is not recommended.